BIG-SERT ® CHECK FOR VALVES BEING CLOSED ON 4 STROKE ENGINE (ANIMATION)

EXHAUST SIDE ->

<- INTAKE SIDE

An optional way to check that the valves are closed.
Have someone turn the engine over by hand with a 18mm socket from the front of the engine.
Turn the engine over until it is going up on the Compression . Place your thumb at the top of the spark plug hole at the same time to block off the air. When you feel the engine compression stop pushing air against your thumb the piston will be top dead center. Turn the engine a little more to be going down on the Power stroke, both valves should be closed at this point, and the piston should all the way down.

Information on todays combustion engines:
Today, internal combustion engines in cars, trucks, motorcycles, aircraft, construction machinery and many others, most commonly use a four-stroke cycle. The four strokes refer to intake, compression, combustion (power), and exhaust strokes that occur during two crankshaft rotations per working cycle of the gasoline engine and diesel engine.

The cycle begins at top dead center (TDC), when the piston is farthest away from the axis of the crankshaft. On the intake or induction stroke of the piston, the piston descends from the top of the cylinder, reducing the pressure inside the cylinder. A mixture of fuel and air is forced (by atmospheric or greater pressure) into the cylinder through the intake (inlet) port. The intake (inlet) valve (or valves) then close(s), and the compression stroke compresses the fuel–air mixture.

The air–fuel mixture is then ignited near the end of the compression stroke, usually by a spark plug (for a gasoline engine) or by the heat and pressure of compression (for a Diesel cycle or compression ignition engine). The resulting pressure of burning gases pushes the piston through the power stroke. In the exhaust stroke, the piston pushes the products of combustion from the cylinder through an exhaust valve or valves.